133 STOP SPINDLEĬause Spindle rotation did not start when the spindle rotation start command was issued during automatic operation. If this alarm message is displayed when the manual feedrate is not 0, check the signal line for a short-circuit. Action Change the manual feedrate to a value greater than 0. 132 FEEDRATE ZEROĬause An attempt has been made to execute an axis movement in the cutting feed mode or dry-run in the automatic operation mode, with the manual feedrate remaining set to 0 on the machine operating panel. If this alarm message is displayed when the cutting-feed override value is not 0, check the signal line for a short-circuit. Action Change the cutting-feed override value to one greater than 0. 131 CUTTING FEED OVERRIDE ZEROĬause The cutting-feed override value is set to 0 on the machine operating panel. Action Contact Mazak Technical Center or Technology Center. 130 NO OPERATION MODEĬause This message is displayed in the event of incorrect mode selection or a mode selector switch malfunction. Action Deactivate the servo-off function. 129 INSIDE INTERLOCK AXISĬause The very direction in which the manual skip function has become effective is specified in the axis-movement command. Action Clear the active state of the interlock function. 128 OUTSIDE INTERLOCK AXISĬause An axis is interlocked because the interlock function has become active (input signal has turned off). Action Set the correct direction (+, –) using the axis selector buttons. FOR ORIGIN RETURNĬause The axis-movement direction selected with the axis selector button is not correct for the reference-point return in manual operation mode. Action First actuate the handle for manual pulse feed to move the axis back in the opposite direction to the zero-point, and then carry out the zero-point returning operation once again. 126 AXIS HAS NOT PASSED Z PHASEĬause During initial reference-point return following the power-on action, an axis has not passed through the Z phase of the corresponding detector. After that, carry out the zero-point returning operation once again. Action Either extend the length of the proximity-point watchdog or reduce the reference-point returning speed. 125 ILLEGAL AXIS EXISTSĬause During reference-point return, the proximity-point detection limit switch has overrun the position in which the watchdog is mounted. Action Move the tool tip away from the end in manual operation mode. 113 OVER TRAVELĬause The tool tip has reached stroke limit in the direction of the axis corresponding to the displayed axis name. Action Modify the program so that the tool tip may move within the area specified in the software limit parameters. 173 2ND SPDL C AXIS NOT AVIALABLE (, , ) B I N RedĬause Some mistake in operations during the automatic operation has caused the tool tip to overstep the area specified in the software limit parameters in the direction of the axis corresponding to the displayed axis name.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |